Connecting to an ACM Appliance

NOTE: Standard and Enterprise Edition only.

Connect an ACM appliance to your site and you can link doors controlled by the appliance to cameras controlled by the ACC software. After doors and cameras are linked, you can configure rules that are triggered by doors in the ACC software.

  1. In the site Setup tab, click .

    The Access Control dialog box is displayed.

  2. Specify the following:
    • Hostname: Enter the hostname or IP address of the ACM appliance.
    • Port: Enter the port number if different from the default port (443).
    • Username: Enter the identity login that was created for adding the ACM appliance to the ACC software.

      For more information, see Before Adding ACM to ACC.

    • Password: Enter the password for the selected Identity.
  3. Click OK.
  4. When you see the Untrusted New Site message, access the ACM application and confirm that the listed SHA-256 fingerprint ID is the same.

    The fingerprint information is typically listed on the Appliance:Edit page, under the SSL Certificate tab.

  5. If the fingerprints are the same, click Trust.

    If the fingerprints do not match, contact your system administrator and inform them of the issue.

The ACM appliance is now listed under the site as Hostname in the Setup tab.

Related Tasks

Before Adding ACM to ACC

Linking Doors to Cameras

Adding a Rule for an ACM Appliance Event

Importing ACM Roles

 

 

Avigilon Control Center 6.6 | 20170922