Adding a Rule

NOTE: sites with a Standard license can have up to 3 rules in their system.

  1. In the site Setup tab, click .

    The Rules dialog box is displayed.

  2. Click Add.
  3. On the Select Rule Event(s) page, select all the events that will trigger the rule. If there is blue underlined text in the rule description, click on the text to further define the event.

    When the trigger event is defined, click .

  4. On the Select Rule Action(s) page, select all the actions that will occur in response to the triggers. If there is blue underlined text in the rule description, click on the text to further define the event.

    When the action is defined, click .

  5. On the Select Rule Condition(s) page, select the specific condition that will cause this rule to run. You can select more than one condition, or select none to ensure the rule is always run.

    If there is blue underlined text in the rule description, click on the text to further define the condition.

    When the condition is defined, click .

  6. On the Select Rule Properties page, complete the following:
    1. Enter a Rule Name: and a Rule Description:.
    2. Select a Schedule: for the rule. For more information, see Scheduling Site Events.
    3. Make sure the Rule is enabled check box is selected to enable the rule.
  7. Click to save the new rule.

 

 

Avigilon Control Center 6.6 | 20170922