Adding a POS Transaction Source

1. In the server Setup tab, click . The POS Transactions dialog box is displayed.
2. Click . The POS Transactions Setup wizard is displayed.
3. On the Set Transaction Source Device page, enter the Hostname/IP Address: and the Port: of the POS transaction source device, then click Next.
4. On the Set Transaction Source Data Format page, select a data format, then click Next.

   To add or edit a data format, click Add or Edit. Alternatively, click Copy From to duplicate then edit the selected data format.

   For more information about adding a new data format, see Adding a Transaction Source Data Format.

5. On the Set Transaction Exceptions page, select any exceptions that need be monitored, then click Next. If you do not need to monitor for exceptions, you can skip this page.

   To add or edit a transaction exception, click Add or Edit. For more information, see Adding a Transaction Exception.

6. On the Set Transaction Source Device page, select the cameras you want to link to the transaction source.

   You can also set the amount of time video needs to be recorded before and after each transaction. The default value is 5 seconds.

   When you are ready to continue, click Next.

7. On the Set Transaction Source Name and Description page, enter a name and description for the transaction source. Select Enable transaction source to start receiving data from the transaction source.
8. Click to save the new transaction source.

 

 

Avigilon Control Center 6.6 | 20170922